Extraction-chromatographic determination of the composition of the gasoline fraction of pyrolyzed automobile tires, hydrogenated on various catalysts
https://doi.org/10.29235/1561-8331-2025-61-4-304-314
Abstract
Using preliminary extraction sample preparation and subsequent GC-MS analysis, as well as standard physicochemical methods for analyzing petroleum products, the hydrocarbon composition of the gasoline fraction (boiling point range of 32–180 °C) of tire pyrolysate was determined before and after its hydrogenation on aluminoplatinum and aluminumnickel-molybdenum catalysts. Using extraction, it was found that the studied fraction contains small amounts of watersoluble components. Treatment of the fraction with oleum made it possible to selectively determine the content of saturated hydrocarbons in the pyrolysate, since alkenes and arenes are destroyed by oleum. Based on the results obtained, it was concluded that the original gasoline fraction of the pyrolysate cannot be used as a component of motor fuels due to the high content of sulfur and alkenes. Hydrogenation on a platinum catalyst significantly reduces the content of sulfur and alkenes, but it remains quite high. The use of an alumina-nickel-molybdenum catalyst in hydrotreating allows for a sharp reduction in the content of the above components, but at the same time the content of aromatic hydrocarbons increases significantly. The pyrolysate obtained during hydrogenation on this catalyst can be considered as a potential additive to commercial petroleum products, since it contains virtually no sulfur or olefins.
About the Authors
S. M. LeschevBelarus
Leschev Sergey M. – Dr. Sc. (Chemistry), Professor
14, Leningradskaya Str., 220030, Minsk
M. F. Zayats
Belarus
Zayats Mikhail F. – Dr. Sc. (Chemistry), Associate Professor, Head of the Department
14, Leningradskaya Str., 220030, Minsk
D. S. Ignatenko
Belarus
Ignatenko Darya S. – Leading Specialist
9, Promyshlenny lane, 222823, Svisloch, Pukhovichi region, Minsk area
A. I. Usevich
Belarus
Usevich Andrew I. – Ph.D. (Chemistry), Associate Professor, Associate Professor Department
13а, Sverdlov Str., 220006 Minsk
K. I. Trusau
Russian Federation
Trusau Kiryl I. – Assistant
13а, Sverdlov Str., 220006 Minsk
K. M. Asipionak
Belarus
Asipionak Katsiaryna M. – Assistant
13а, Sverdlov Str., 220006 Minsk
P. V. Kurman
Belarus
Kurman Peter V. – Ph. D. (Chemistry), Leading Researcher
5/2, Akademician Kupre- vich Str., 220084, Minsk
References
1. Nkosi N., Muzenda E. A review and discussion of waste tire pyrolysis and derived products proceedings. The World Congress on Engineering WCE 2014, July 2–4, 2014, vol. 2. London, U.K., 2014, pp. 979–985.
2. Kalitko U., Chun Yao Wu M. Tire scrap pyrolysis recycling by steaming way: heat-mass balance solutions and deve- lopments. Donahue W. S., Brandt J. C. (eds.). Pyrolysis: Types, Processes. Nova Science Publishers, Inc., 2009, pp. 1–37.
3. Quek A., Balasubramanian R. Liquefaction of waste tires by pyrolysis for oil and chemicals – a review. Journal of Analytical and Applied Pyrolysis, 2013, vol. 101, pp. 1–16. https://doi.org/10.1016/j.jaap.2013.02.016
4. Perondi D., Scopel B. S., Collazzo G. C., Silva J. P., Botomé M. L., Dettmer A., Godinho M., Vilela A. C. F. Charac- teristics of pyrolysis products from waste tires and spent foundry sand co-pyrolysis progress in rubber. Progress in Rubber, Plastics and Recycling Technology, 2016, vol. 32, no. 4, pp. 213–240. https://doi.org/10.1177/147776061603200403
5. Islam M. R., Parveen M., Haniu H., Sarker M. R. I. Innovation in pyrolysis technology for management of scrap tire: a solution of energy and environment. International Journal of Environmental Science and Development, 2010, vol. 1, no. 1, pp. 89–96. https://doi.org/10.7763/ijesd.2010.v1.18
6. Khan M. Z. H., Hossain Md. I., Halder P. K., Hasan Md. R., Mamun Md. R. A. Fuel properties of pyrolytic tire oil and its blends with diesel fuel – towards waste management. International Journal of Environment and Waste Management, 2016, vol. 18, no. 4, pp. 335–348. https://doi.org/10.1504/ijewm.2016.081835
7. Ilkilic, C., Aydın H. Fuel production from waste vehicle tires by catalytic pyrolysis and its application in a diesel engine. Fuel Processing Technology, 2011, vol. 92, pp. 1129–1135. https://doi.org/10.1016/j.fuproc.2011.01.009
8. Alvarez J., Lopez G., Amutio M., Mkhize N. M., Danon B., van der Gryp P., Görgens J. F., Bilbao J., Olazar M. Eva- luation of the properties of tire pyrolysis oils obtained in a conical spouted bed reactor. Energy, 2017, vol. 128, pp. 463–474. https://doi.org/10.1016/j.energy.2017.03.163
9. Rowhani A., Rainey Th. J. Scrap Tire Management Pathways and Their Use as a Fuel – a Review. Energies, 2016, vol. 9, no. 11, pp. 888–913. https://doi.org/10.3390/en9110888
10. Genarova T. N., Leshchev S. M. Analysis of liquid products of pyrolysis of rubber waste. Minsk, ITMO, 2022. 243 p. (in Russian).
11. Radchenko E. D., Nefedov B. K., Aliev R. R. Industrial catalysts for hydrogenation processes in oil refining. Moscow, Khimiya Publ., 1987. 224 p. (in Russian).
12. State Standard 3900-2022. Oil and oil products. Methods for determining density. Minsk, Interstate Council for Standardization, Metrology and Certification, 2023. 48 p. (in Russian).
13. State Standard 18995.2-2022. Liquid chemical products. Method for determination of refractive index. Moscow, Russian Institute of Standardization, 2023. 8 p. (in Russian).
14. State Standard 2070-82. Light petroleum products. Methods for determination of iodine numbers and content of unsa- turated hydrocarbons. Moscow, State Committee for Standards of the USSR, 1983. 6 p. (in Russian).
15. State Standard 5985-2022. Petroleum products. Method for determination of acidity and acid number. Moscow, Russian Institute of Standardization, 2023. 16 p. (in Russian).
16. State Standard 32403-2013. Petroleum products. Determination of sulfur content (lamp method). Moscow, Standartin- form Publ., 2014. 24 p. (in Russian).
17. State Standard 21261-2021. Petroleum products. Method for determining the higher calorific value and calculating the lower calorific value. Moscow, Russian Institute of Standardization, 2022. 30 p. (in Russian).
18. Recommendations for measuring the molecular weight of oil by cryoscopy in benzene using the Krion-1 installation. Available at: cdn.termexlab.ru/files/c9a56e94/50bd/4281/8d68/b35f5373ac09.pdf (Accessed 7 May 2024) (in Russian).
19. State Standard 12329-2021. Petroleum products and hydrocarbon solvents. Method for determination of aniline point and aromatic hydrocarbons. Moscow, Russian Institute of Standardization, 2022. 17 p. (in Russian).
20. Ouedraogo A. S., Bhoi P. R. Recent progress of metals supported catalysts for hydrodeoxygenation of biomass derived pyrolysis oil. Journal of Cleaner Production. 2020, vol. 253, Art. 119957. https://doi.org/10.1016/j.jclepro.2020.119957.
21. Unleaded gasoline AI-92-K5-Euro «BN». Available at: https://v.belorusneft.by/sitebeloil/ru/center/azs/center/fuelandService/quality/benzin-avtomobilnyj-bn92/ (Accessed 2 May 2025) (in Russian).



























